NetApp StorageGRID SG6000 Manual page 105

Code
0xED
0xEE
0xEF
0xF0
0xF1
0xF2
0xF3
0xF4
0xF5
0x70
0x74
0xF6
0xF7
0xF8
0xF9
Hardware setup appears to hang (SG6000)
The StorageGRID Appliance Installer might not be available if hardware faults or cabling
errors prevent the storage controllers or the SG6000-CN controller from completing their
boot-up processing.
Steps
1. For the storage controllers, watch the codes on the seven-segment displays.
While the hardware is initializing during power up, the two seven-segment displays show a sequence of
codes. When the hardware boots successfully, both seven-segment displays show 99.
2. Review the LEDs on the SG6000-CN controller and the boot-up and error codes displayed in the BMC.
3. If you need help resolving an issue, contact technical support.
Indicates
MRC: ERR_DIMM_COMPAT
MRC: ERR_MRC_COMPATIBILITY
MRC: ERR_MRC_STRUCT
MRC: ERR_SET_VDD
MRC: ERR_IOT_MEM_BUFFER
MRC: ERR_RC_INTERNAL
MRC: ERR_INVALID_REG_ACCESS
MRC: ERR_SET_MC_FREQ
MRC: ERR_READ_MC_FREQ
MRC: ERR_DIMM_CHANNEL
MRC: ERR_BIST_CHECK
MRC: ERR_SMBUS
MRC: ERR_PCU
MRC: ERR_NGN
MRC: ERR_INTERLEAVE_FAILURE
103