NetApp StorageGRID SG6000 Manual page 125

this issue.
▪ SPM Verify Database Controller check fails
A storage partitions mapping database error occurred on a controller. Contact technical support to
resolve this issue.
▪ Configuration Database Validation (If supported by the storage array's controller version)
A configuration database error occurred on a controller. Contact technical support to resolve this
issue.
▪ MEL Related Checks
Contact technical support to resolve this issue.
▪ More than 10 DDE Informational or Critical MEL events were reported in the last 7 days
Contact technical support to resolve this issue.
▪ More than 2 Page 2C Critical MEL Events were reported in the last 7 days
Contact technical support to resolve this issue.
▪ More than 2 Degraded Drive Channel Critical MEL events were reported in the last 7 days
Contact technical support to resolve this issue.
▪ More than 4 critical MEL entries in the last 7 days
Contact technical support to resolve this issue.
6. If this procedure completed successfully and you have additional procedures to perform while the node is
in maintenance mode, perform them now. When you are done, or if you experienced any failures and want
to start over, select Advanced > Reboot Controller, and then select one of these options:
◦ Select Reboot into StorageGRID
◦ Select Reboot into Maintenance Mode to reboot the controller with the node remaining in
maintenance mode. Select this option if you experienced any failures during the procedure and want to
start over. After the node finishes rebooting into maintenance mode, restart from the appropriate step in
the procedure that failed.
123