NetApp StorageGRID SG6000 Manual page 81

Enter the Destination IP for each SNMP trap using an IP address. Fully qualified domain
names are not supported.
Enable traps if you want the SG6000-CN controller to send immediate notifications to an SNMP console
when it is in an unusual state. Traps might indicate hardware failures of various components or
temperature thresholds being exceeded.
4. Optionally, click Send Test Trap to test your settings.
5. If the settings are correct, click Save.
Set up email notifications for alerts
If you want email notifications to be sent when alerts occur, you must use the BMC
interface to configure SMTP settings, users, LAN destinations, alert policies, and event
filters.
BMC settings made by this procedure might not be preserved if the SG6000-CN fails and has to
be replaced. Make sure you have a record of all settings you have applied, so they can be easily
reapplied after a hardware replacement if necessary.
What you'll need
You know how to access the BMC dashboard.
About this task
In the BMC interface, you use the SMTP Settings, User Management, and Platform Event Filters options on
the Settings page to configure email notifications.
Steps
1. Configure the SMTP settings.
a. Select Settings > SMTP Settings.
b. For Sender Email ID, enter a valid email address.
This email address is provided as the From address when the BMC sends email.
2. Set up users to receive alerts.
a. From the BMC dashboard, select Settings > User Management.
79