NetApp StorageGRID SG6000 Manual page 107

link-local IP
169.254.0.1
detailed instructions, see step 2 in
If that does not resolve the issue, contact technical support.
e. If the ping was successful, open a web browser.
f. Enter the URL for the StorageGRID Appliance Installer:
https://SG6000-CN_Controller_IP:8443
The Home page appears.
Expansion shelves do not appear in Appliance Installer
If you have installed expansion shelves for the SG6060 and they do not appear in the
StorageGRID Appliance Installer, you should verify that the shelves have been
completely installed and powered on.
About this task
You can verify that the expansion shelves are connected to the appliance by viewing the following information
in the StorageGRID Appliance Installer:
• The Home page contains a message about expansion shelves.
• The Advanced > RAID Mode page indicates by number of drives whether or not the appliance includes
expansion shelves. For example, in the following screen shot, two SSDs and 178 HDDs are shown. An
SG6060 with two expansion shelves contains 180 total drives.
If the StorageGRID Appliance Installer pages do not indicate that expansion shelves are present, follow this
procedure.
Steps
1. Verify that all required cables have been firmly
2. Verify that you have
3. If you need help resolving an issue, contact technical support.
Reboot SG6000-CN controller while StorageGRID Appliance Installer is running
You might need to reboot the SG6000-CN controller while the StorageGRID Appliance
to check controller networking configuration and update if necessary. For
Accessing StorageGRID Appliance
powered on the expansion
connected.
shelves.
Installer.
105