NetApp StorageGRID SG6000 Manual page 160

2. Make the desired changes to the link configuration.
For more information on the options, see
3. When you are satisfied with your selections, click Save.
You might lose your connection if you made changes to the network or link you are
connected through. If you are not reconnected within 1 minute, re-enter the URL for the
StorageGRID Appliance Installer using one of the other IP addresses assigned to the
appliance:
https://Appliance_Controller_IP:8443
If you made changes to the VLAN settings, the subnet for the appliance might have changed. If you need
to change the IP addresses for the appliance, follow the
Configure StorageGRID IP addresses
4. Select Configure Networking > Ping Test from the menu.
5. Use the Ping Test tool to check connectivity to IP addresses on any networks that might have been
affected by the link configuration changes you made in the
In addition to any other tests you choose to perform, confirm that you can ping the Grid Network IP address
of the primary Admin Node, and the Grid Network IP address of at least one other Storage Node. If
necessary, return to the
6. When you are satisfied that your link configuration changes are working and you have additional
procedures to perform while the node is in maintenance mode, perform them now. When you are done, or
if you experienced any failures and want to start over, select Advanced > Reboot Controller, and then
select one of these options:
◦ Select Reboot into StorageGRID
◦ Select Reboot into Maintenance Mode to reboot the controller with the node remaining in
maintenance mode. Select this option if you experienced any failures during the procedure and want to
start over. After the node finishes rebooting into maintenance mode, restart from the appropriate step in
the procedure that failed.
158
Configure network links
link configuration changes
(SG6000).
Configure IP addresses
link configuration changes
step and correct any link configuration issues.
instructions.
step.