NetApp StorageGRID SG6000 Manual page 77

About this task
For support purposes, the BMC management port allows low-level hardware access.
You should only connect this port to a secure, trusted, internal management network. If no such
network is available, leave the BMC port unconnected or blocked, unless a BMC connection is
requested by technical support.
Steps
1. From the client, enter the URL for the StorageGRID Appliance Installer:
https://SG6000-CN_Controller_IP:8443
For SG6000-CN_Controller_IP, use the IP address for the appliance on any StorageGRID network.
The StorageGRID Appliance Installer Home page appears.
2. Select Configure Hardware > BMC Configuration.
The Baseboard Management Controller Configuration page appears.
3. Make a note of the IPv4 address that is automatically displayed.
DHCP is the default method for assigning an IP address to this port.
It might take a few minutes for the DHCP values to appear.
75