Install Hardware (Sg6000) - NetApp StorageGRID SG6000 Manual

Management Interface (IPMI) standard.
Information needed
Ethernet switch port you will connect to the BMC
management port (circled in the diagram)
DHCP-assigned IP address for the BMC management
network, if available after power on
Static IP address you plan to use for the BMC
management port
Related information
Controllers in SG6000 appliances
Review appliance network connections (SG6000)
Port bond modes for SG6000-CN controller
Cable appliance (SG6000)
Configure StorageGRID IP addresses

Install hardware (SG6000)

Hardware installation entails installing the SG6000-CN controller and the storage
controller shelf into a cabinet or rack, connecting the cables, and applying power.
Register hardware
Registering the appliance hardware provides support benefits.
Steps
1. Locate the chassis serial number for the storage controller shelf.
You can find the number on the packing slip, in your confirmation email, or on the appliance after you
unpack it.
There are several serial numbers on the storage appliance. The serial number on the
storage controller shelf is the one that must be registered and used if you call for service or
support on the appliance.
Your value
• IPv4 address (CIDR):
• Gateway:
• IPv4 address (CIDR):
• Gateway:
29