NetApp StorageGRID SG6000 Manual page 80

4. Optionally, create additional users by selecting Settings > User Management and clicking on any
"disabled" user.
When users sign in for the first time, they might be prompted to change their password for
increased security.
Configure SNMP settings for SG6000-CN controller
If you are familiar with configuring SNMP for hardware, you can use the BMC interface to
configure the SNMP settings for the SG6000-CN controller. You can provide secure
community strings, enable SNMP Trap, and specify up to five SNMP destinations.
What you'll need
• You know how to access the BMC dashboard.
• You have experience in configuring SNMP settings for SNMPv1-v2c equipment.
BMC settings made by this procedure might not be preserved if the SG6000-CN fails and has to
be replaced. Make sure you have a record of all settings you have applied, so they can be easily
reapplied after a hardware replacement if necessary.
Steps
1. From the BMC dashboard, select Settings > SNMP Settings.
2. On the SNMP Settings page, select Enable SNMP V1/V2, and then provide a Read-Only Community
String and a Read-Write Community String.
The Read-Only Community String is like a user ID or password. You should change this value to prevent
intruders from getting information about your network setup. The Read-Write Community String protects
the device against unauthorized changes.
3. Optionally, select Enable Trap, and enter the required information.
78