NetApp StorageGRID SG6000 Manual page 58

You must either assign a static IP for the appliance on each connected network or assign a permanent lease
for the address on the DHCP server.
If you want to change the link configuration, see the
SG6000-CN controller.
Steps
1. In the StorageGRID Appliance Installer, select Configure Networking > IP Configuration.
The IP Configuration page appears.
2. To configure the Grid Network, select either Static or DHCP in the Grid Network section of the page.
3. If you selected Static, follow these steps to configure the Grid Network:
56
instructions for changing the link configuration of the