NetApp StorageGRID SG6000 Manual page 50

https://169.254.0.1:8443
The StorageGRID Appliance Installer Home page appears. The information and messages shown
when you first access this page depend on how your appliance is currently connected.
If you cannot access the Home page over a link-local connection, configure the service
laptop IP address as 169.254.0.2, and try again.
After you finish
After accessing the StorageGRID Appliance Installer:
• Verify that the StorageGRID Appliance Installer version on the appliance matches the software version
installed on your StorageGRID system. Upgrade StorageGRID Appliance Installer, if necessary.
Verify and upgrade StorageGRID Appliance Installer version
• Review any messages displayed on the StorageGRID Appliance Installer Home page and configure the
link configuration and the IP configuration, as required.
Related information
Web browser requirements
Verify and upgrade StorageGRID Appliance Installer version
The StorageGRID Appliance Installer version on the appliance must match the software
version installed on your StorageGRID system to ensure that all StorageGRID features
are supported.
What you'll need
You have accessed the StorageGRID Appliance Installer.
About this task
StorageGRID appliances come from the factory preinstalled with the StorageGRID Appliance Installer. If you
are adding an appliance to a recently upgraded StorageGRID system, you might need to manually upgrade the
StorageGRID Appliance Installer before installing the appliance as a new node.
The StorageGRID Appliance Installer automatically upgrades when you upgrade to a new StorageGRID
version. You do not need to upgrade the StorageGRID Appliance Installer on installed appliance nodes. This
procedure is only required when you are installing an appliance that contains an earlier version of the
StorageGRID Appliance Installer.
Steps
1. From the StorageGRID Appliance Installer, select Advanced > Upgrade Firmware.
2. Compare the Current Firmware version to the software version installed on your StorageGRID system.
(From the top of the Grid Manager, select the help icon and select About.)
The second digit in the two versions should match. For example, if your StorageGRID system is running
version 11.6.x.y, the StorageGRID Appliance Installer version should be 3.6.z.
3. If the appliance has a down-level version of the StorageGRID Appliance Installer, go to the
Downloads page for
48
StorageGRID.
NetApp