NetApp StorageGRID SG6000 Manual page 144

Power on SG6000-CN controller and verify operation
Power on the controller after completing maintenance.
What you'll need
• You have installed the controller in a cabinet or rack and connected the data and power cables.
Reinstall SG6000-CN controller into cabinet or rack
• You have physically located the controller in the data center.
Locate controller in data center
Steps
1. Power on the SG6000-CN controller and monitor the controller LEDs and boot-up codes using one of the
following methods:
◦ Press the power switch on the front of the controller.
◦ Use the controller BMC interface:
i. Access the controller BMC interface.
Access BMC interface
ii. Select Power Control.
iii. Select Power On Server and then select Perform Action.
142