NetApp StorageGRID SG6000 Manual page 134

◦ Check the tags attached to the front of each controller for a matching part number.
2. Remove the controller front bezel, if one is installed, to access the front panel controls and indicators.
3. Optional: Turn off the blue identify LED if you used it to locate the controller.
◦ Press the identify LED switch on the controller front panel.
◦ Use the controller BMC interface.
Turn controller identify LED on and off
Related information
Remove Fibre Channel HBA
Remove SG6000-CN controller from cabinet or rack
Shut down SG6000-CN controller
Replace storage controller
You might need to replace an E2800 controller or an EF570 controller if it is not
functioning optimally or if it has failed.
What you'll need
• You have a replacement controller with the same part number as the controller you are replacing.
• You have labels to identify each cable that is connected to the controller.
• You have an ESD wristband, or you have taken other antistatic precautions.
• You have a #1 Phillips screwdriver.
• You have the E-Series instructions for replacing a controller in duplex configuration.
Refer to the E-Series instructions only when directed or if you need more details to perform
a specific step. Do not rely on the E-Series instructions to replace a controller in the
StorageGRID appliance, because the procedures are not the same.
• You have physically located the storage appliance where you are replacing the controller in the data center.
Locate controller in data center
132