Front Gearcase Assembly - Polaris RANGER XP 900 2013 Manual

FRONT GEARCASE ASSEMBLY

1. As mentioned during gearcase disassembly section,
replace all O-rings, seals and worn components.
2. Install pinion shaft assembly and install internal snap
ring.
NOTE
If bearing replacement was required, press new bearing
onto the pinion shaft and install a new external snap
ring.
3. Install a new pinion shaft seal into the pinion gear
housing. Using a universal seal installer, press the
new seal into the housing until the seal is just below
the housing chamfer.
4. Install the RH output hub into the gearcase housing.
9924880 Rev 2- 1/10/2014 - 2013 / 2014 RANGER XP 900 - 2014 RANGER XP 900 / CREW 900 Service Manual
© Copyright Polaris Sales Inc.
5. Carefully install the rollers into the roll cage
assembly while installing the assembly into the
clutch housing.
NOTE
Install the roll cage so that the ring gear grooves line up
with the roll cage slots (see below).
6. Install the torsion spring by wrapping each leg of the
spring around the dowel pin on the ring gear.
FINAL DRIVE
7
7.19