Change Parameter Setting Values - YASKAWA GA800 Maintenance & Troubleshooting

4.
Push or
The screen will show the monitors as shown in this figure.
Note:
Push [Hold] to switch between Pause and Restart for the monitor display. The "Hold (ENTER)" message flashes while you pause
monitoring.
◆

Change Parameter Setting Values

This example shows how to change the setting value for C1-01 [Acceleration Time 1]. Do the steps in this procedure
to set parameters for the application.
1.
Push (Home) to show the HOME screen.
Note:
• When the drive is in HOME Mode, the screen shows [Home] in the upper right-hand corner of the screen.
• If [Home] is not shown above the
2.
Push (Menu).
3.
Push or
4.
Push or
YASKAWA TOEPYAIGA8001B GA800 Drive Maintenance & Troubleshooting
to select [Trend Plot], then push
, push (Back).
to select [Parameters], then push
to select [C Tuning], then push
.
.
.
6.6 Keypad Operation
461
6