YASKAWA GA800 Maintenance & Troubleshooting page 321

1.
Use the panel cut-out dimensions in
keypad.
Figure 4.15 Panel Cut-Out Dimensions to Attach Inside Control Panel
W
64 + 0.5
(2.52 + 0.02)
2.
Remove the keypad and put the keypad connector in the holder on the front cover.
Note:
Insert the end of the keypad connector that has the tab.
A - Keypad
B - Keypad connector
3.
Use the screws included with the mounting bracket, and attach the keypad to the mounting bracket.
Use the screws included with the installation support set to attach it. Tighten the screws to a correct tightening
torque:
• M3 screws: 0.49 N∙m to 0.73 N∙m (4.34 in∙lb to 6.46 in∙lb)
YASKAWA TOEPYAIGA8001B GA800 Drive Maintenance & Troubleshooting
4.7 Install the Keypad in a Control Panel or Another Device
Figure 4.15 and Table 4.10
Table 4.10 Panel Cut-Out Dimensions mm (in)
H W1
130 45
(5.12) (1.77)
C - Holder
Figure 4.16 Remove the Keypad
to cut an opening in the control panel for the
H1
105 + 0.5
(4.13 + 0.02)
d
4.8
(0.12)
4
321