YASKAWA GA800 Maintenance & Troubleshooting page 319

W H
65 106
*1 Minimum bending radius
■
Mount to the Outside of Control Panel
1.
Use the dimensions in
Figure 4.11 External/Face Mount Enclosure Panel Cut-Out Dimensions
W
22
(0.89)
2.
Remove the keypad and put the keypad connector in the holder on the front cover.
Note:
Insert the end of the keypad connector that has the tab.
A - Keypad
B - Keypad connector
3.
Put the keypad on the outside of the control panel.
Use M3 screws (6 mm (0.2 in) depth cross-recessed pan head screws) to attach the keypad from the inside.
Tighten the screws to a correct tightening torque:
• M3 screws: 0.49 N∙m to 0.73 N∙m (4.34 in∙lb to 6.46 in∙lb)
YASKAWA TOEPYAIGA8001B GA800 Drive Maintenance & Troubleshooting
4.7 Install the Keypad in a Control Panel or Another Device
Table 4.8 Exterior Dimensions (mm)
D D1 D2
16 8.2 1.6
Figure 4.11 and Table 4.9
Table 4.9 Panel Cut-Out Dimensions mm (in)
H W1
78 22
(3.07) (0.89)
Figure 4.12 Remove the Keypad
R *1 W1
53.8 44
to cut an opening in the control panel for the keypad.
H1 H2
29 22
(1.14) (0.89)
C - Holder
W2 H1 d
15 78 M3
H3 d
1 3.6
(0.04) (0.14)
4
319