YASKAWA GA800 Maintenance & Troubleshooting page 409

5.
Remove the main circuit terminal block nut.
A - Nut
6.
Wire the closed-loop crimp terminal to the main circuit terminal block.
7.
Tighten the nut to the specified torque.
8.
Attach the wiring cover and terminal block cover to their initial positions and tighten the screws on the terminal
block cover.
Note:
6-Phase/12-pulse drives (models: Txxx) do not have the wiring covers.
YASKAWA TOEPYAIGA8001B GA800 Drive Maintenance & Troubleshooting
Figure 5.82 Remove the Terminal Block Nut
Figure 5.83 Connect the Wire
Figure 5.84 Tighten the Terminal Block Nut
5.9 Braking Resistor Installation
5
409