Show The Monitor - YASKAWA GA800 Maintenance & Troubleshooting

6.6 Keypad Operation
■
Change the Frequency Reference Value
1. Push to access the screen to change the frequency.
2. Push or to select the digit to change, then push
3. Push to keep the changes.
Note:
The HOME screen must show U1-01 [Frequency Reference] or you must set the keypad as the Run command source (REMOTE) to use this
function.
■
Show the Main Menu
Push to show the main menu. Push
◆

Show the Monitor

This section shows how to show the standard monitors (Ux-xx).
1.
Push [Home] to show the HOME screen.
Note:
• When the drive is in HOME Mode, the screen shows [Home] in the upper right-hand corner of the screen.
• If [Home] is not shown on
2.
Push (Menu).
3.
Push or
4.
Push or
450
[HOME] to go back to the HOME screen.
, push (Back) to show [Home] on
to select [Monitors], then push
to select [Standard Monitor], then push
or to change the value.
.
.
.
YASKAWA TOEPYAIGA8001B GA800 Drive Maintenance & Troubleshooting