If An Alarm Occurs; Rs-2323 Computer Link; Connect To A Computer - CareFusion Alaris SE User Manual

General Setup and Operation
Nurse Call—7130/7230 Only (Continued)
1. Determine cause and appropriate corrective action (see
Alarms, Alerts, Prompts on page 108).
2. Reset nurse call system, as required.
The optional Computer Link feature allows a hospital/facility
computer to interact with the instrument. The computer cannot
start or stop the instrument, set the rate, or make any change in
status. The feature may be enabled or disabled by qualified
personnel in the instrument configuration settings. If the
feature is enabled (On) the user may select Monitor, to allow
the computer to receive information from the instrument, or Off.
When Off is selected, the computer cannot communicate with
the instrument.
To ensure continued electromagnetic compatibility
performance, the communications cable attached to the
instrument should be no longer than
have fully shielded connector housings, and have a
coverage braid/foil shield attached to the connector housings
around the signal conductors with the cable jacket.

Connect to a Computer

1. Press
OPTIONS
2. To advance to next page, press page soft key.
3. Press Computer Link soft key.
4. Press Monitor soft key.
5. Press ok soft key.
User Manual—Alaris SE Pump, Rev2.X
Models 7100/7130, 7200/7230

If an Alarm Occurs

RS-2323 Computer Link

feet
3
key.
inches or meter,
3 1
100%
RS-2323 Computer Link
WARNING
•
Use of any accessory or cable
other than those specified might
result in increased emissions or
decreased Alaris SE pump
immunity.
• The protective cover over the
connector must remain in
RS-232
place when the connector is not
in use.
•
Only equipment that complies
IEC EN 60601-1
with
(approved medical or hospital
signaling equipment) is to be
connected to the
connector.
UL 1069
or
RS-232
71