Advertisement
Table of Contents
MedSystem III
QUICK REFERENCE GUIDE
WARNINGS
To ensure proper operation of the MedSystem III
must be familiar with related features, setup, programming, and IV sets
and accessories prior to use.
This guide is not intended to be comprehensive instructions for the setup
and operation of the MedSystem III
along with Warnings and Cautions, refer to the MedSystem III
Directions for Use.
San Diego, CA 800.854.7128
©2001-2012 CareFusion or one of its subsidiaries. All rights reserved.
infusion pump
®
MedSystem III
O N / O F F
STANDARD
MORE
START
DISPLAY
OPTIONS
STOP
A
B
C
infusion pump, the user
®
infusion pump. For complete instructions
®
infusion pump
®
12279134
Advertisement
Table of Contents
Related Manuals for CareFusion MedSystem III
Summary of Contents for CareFusion MedSystem III
- Page 1 This guide is not intended to be comprehensive instructions for the setup and operation of the MedSystem III infusion pump. For complete instructions ® along with Warnings and Cautions, refer to the MedSystem III infusion pump ® Directions for Use.
-
Page 2: More Options
To Prime the Administration Set channel. 1. Use only MedSystem III administration ® To Change Rate or VTBI sets. 1. Select channel by pressing "A, or C". 2. Close roller clamp. Spike container. Fill drip 2. Change the rate using ↑, ↓, Fast ↑, or Fast chamber to approximately half full. - Page 3 Indefinitely - "Standby" Status 3.Press SELECT to highlight the value you wish to program (Rate or Volume 1. Select channel by pressing "A, or C". Remaining or to clear the Volume Infused.) 2. Press START/STOP. Press STANDARD 4. Use ↑, ↓, Fast ↑, or Fast ↓ to reach the DISPLAY.
-
Page 4: Advanced Features
To Turn Pump Off To View Dose Rate Program 1. Hold the ON/OFF key in for one full Parameters second. 1. Select channel by pressing "A, or C". Dose Rate Calculation programming page will ADVANCED FEATURES display. To Program a Dose Rate Calculation To Change Dose or Rate (Titrate During Infusion) Note: Infusion must be stopped before 1. -
Page 5: Alarm Response
ALARM RESPONSE STANDARD DISPLAY. Red LED on the affected channel will flash. Advisory 1. Press QUIET to silence. Two beeps will accompany advisory description 2. Press the alarming channel, A, B, or C, to message on STANDARD DISPLAY. access alarm information and follow the Red LED on the affected channel will flash. -
Page 6: Troubleshooting
TROUBLESHOOTING CHECK FLUID SIDE Alarm indicates that flow is restricted upstream Pumping Latch Closed (pump to container). Fault message indicates that the pumping latch 1. Press the alarming channel, A, B, or C, to jaw, next to the air sensor, is in the closed access alarm information and follow the position.
Need help?
Do you have a question about the MedSystem III and is the answer not in the manual?
Questions and answers