Service Information; Technical Support - CareFusion Alaris SE User Manual

Table of Contents

Troubleshooting and Maintenance

Verify that

RS-232

Use a soft cloth dampened with warm water and a mild,

nonabrasive cleaning solution.

•

A soft-bristled brush may be used to clean narrow

areas.

•

Use light pressure when cleaning pressure transducer

and air-in-line detector areas of pumping channels.

Routinely clean flow sensor by running warm water over it

while actuating slider, and then thoroughly dry it.

If the instrument shows evidence of damage in transit, notify

the carrier's agent immediately. Do not return damaged

equipment to the factory before the carrier's agent has

authorized repairs.

If the instrument fails to respond as described in this document

and the cause cannot be determined, do not use the

instrument. Contact qualified CareFusion service personnel.

If it is necessary to return the instrument for service, obtain a

return authorization number prior to shipment. Carefully

package the instrument (preferably in the original packaging),

reference the return authorization information, and return it to

the appropriate service or distribution center. CareFusion does

not assume any responsibility for loss of, or damage to,

returned instruments while in transit.

Technical support, service information, applications, and

manuals may be obtained by contacting a CareFusion

representative. When submitting any request for service,

include:

•

model number

•

a description of difficulty experienced

•

instrument settings

•

administration set/lot number

•

solution(s) used

•

message displayed at time of difficulty

User Manual—Alaris SE Pump, Rev2.X

Models 7100/7130, 7200/7230

Cleaning (Continued)

connector is covered.