Functional Test - CareFusion Alaris SE User Manual

Getting Started
Check-In and Configuration (Continued)
Set Sensor Check/Pressure Calibration Verification
4. Install a standard set and close latch. Verify that reading is
over , to confirm set sensor operation.
170
5. Remove standard set and verify that Sensor = reading is
in - mmHg to +
80
calibration.
If reading is out of range, refer to Technical Service
Manual, Pressure Calibration section, or contact
CareFusion Technical Support for assistance.
1. Turn instrument on without set installed. Verify that it
beeps and that red alarm light flashes but does not stay lit.
2. Set infusion rate to
3. With latch closed, press
≠
to cause Set Out and Air In Line messages.
VTBI 0
4. Open latch.
5. Install primed administration set with latch open.
6. Verify that instrument displays Air In Line and Latch
Open messages.
7. Close latch and verify that display returns to setup page.
8. Perform Upstream Occlusion Test, as follows:
a. Verify that infusion rate is set to
b. With instrument on hold, or at start-up, verify that
primary
VTBI
c. Press
RUN/HOLD
d. Clamp off
IV
inches—to simulate an upstream occlusion.
e. Verify that instrument stops running, alarms, and
displays
OCCLUSION UPSTREAM
12
(Continued)
mmHg range, to verify pressure
30

Functional Test

mL/h and
460 VTBI
key, and rate and
RUN/HOLD
460
is set to greater than
key to begin infusion.
line just above instrument—about two
within
to mL.
100
mL/h.
mL.
100
seconds.
60
Check-In and Configuration
User Manual—Alaris SE Pump, Rev2.X
Models 7100/7130, 7200/7230