Setup - CareFusion Alaris SE User Manual

Programming
1. Open secondary administration set package, remove set,
and close clamp.
2. Insert administration set spike into prepared fluid container
and hang secondary container, following accepted
hospital/facility procedure.
3. Fill drip chamber to ⅔ full.
4. Open secondary administration set clamp and prime set.
5. Close clamp.
6. Attach secondary administration set to upper injection site
on primary set.
7. Using hanger(s) provided with secondary administration
set, lower primary fluid container until bottom of secondary
container is at least
container.
Hanger
at least 9 " ½
Primary Container
User Manual—Alaris SE Pump, Rev2.X
Models 7100/7130, 7200/7230
Secondary Infusion (Continued)

Setup

inches above fluid level in primary
9½
Secondary Container
Secondary Infusion
23