Table of Contents
Advertisement
THE DEVICE SETUP MENU
4.1.2 System Time
This field displays the time currently set at the TRMM/TRMMIM.
To edit this field:
1. Highlight the field.
2. Type in the time using the hh:mm:ss (24-hour) format.
3. Press Enter. If the time is valid, the "OK" message appears.
If the time is invalid, the "Unable to set time..." message appears.
Re-enter the time using the correct format.
4. If the time is correct, highlight the SAVE command at the bottom of
the screen and press Enter. The "Saved" message appears on the
screen, indicating that your changes have been saved to memory.
4.1.3 IP Address
This field displays the Internet Protocol (IP) address, which acts as a
logical identifier on the network, currently assigned to the management
module. This is needed for SNMP network management capability. The IP
address is expressed in dotted decimal notation (four decimal values
between 0 and 255, separated by a period, e.g., 123.123.123.123).
With the correct security access, you can edit the IP address as follows:
1. Highlight the IP Address field.
2. Type the address into this field. The format for this entry is dotted
decimal notation (xxx.xxx.xxx.xxx, with the value of xxx ranging
from 0 to 255). The screen beeps if non-numerics or adjacent dots are
entered. If the entry does not have three separator dots, it will be
rejected.
3. Press Enter. The new IP address is displayed. The natural subnet mask
for the user is also generated and displayed. Read the following section
for more information on the subnet mask.
4. Highlight the SAVE command and press Enter. The "Saved"
message will appear. The changes are saved to memory and will take
effect immediately.
4-4
Advertisement
Table of Contents
