Unpacking The Module; Installing Hsim Or Vhsim Options; Installing Gpim Options; Installing The Module Into The 6C105 Chassis - Cabletron Systems SmartSwitch 6000 Installation & User Manual

Unpacking the Module

3.1 UNPACKING THE MODULE
1. Open the box and remove the packing material protecting the module.
2. Verify the contents of the carton as listed in
3.2

INSTALLING HSIM OR VHSIM OPTIONS

If installing an optional HSIM or VHSIM, it must be installed in the 6H252-17 before proceeding
to Section 3.4. Complete instructions for installing an optional HSIM or VHSIM are available in
the applicable HSIM or VHSIM User's Guide. For details on how to get manuals, refer to the
Related Manuals in the
connector locations.
3.3

INSTALLING GPIM OPTIONS

The optional GPIMs may be installed before or after the 6H262-18 is installed in the 6C105
chassis. The GPIMs are hot swappable, and therefore may also be installed even when the module
has power applied. Refer to
GPIMs.
3.4

INSTALLING THE MODULE INTO THE 6C105 CHASSIS

Failure to observe static safety precautions could cause damage to the SmartSwitch.
!
Follow static safety handling rules and wear the antistatic wrist strap provided with the
CAUTION
6C105 chassis.
Do not cut the non-conductive bag to remove the module. Damage could result from
sharp objects contacting the board or components.
The SmartSwitches can be installed in any of the 5 slots that are available. To install a module,
refer to Figure 3-1 and proceed as follows:
3-2 Installation
Table 3-1 Contents of Shipping Container
Item
1 module, either the 6H202-24,
6H252-17, or 6H262-18
Manual Accessory Kit
About This Guide preface. Refer to
Section 3.6 for installation and connecting the network to any optional
Table 3-1.
Quantity
1
1
Appendix C for the HSIM or VHSIM