Siemens SIMATIC ET 200AL System Manual page 477

Technical specifications
6.1 Technical specifications
Article number
Load resistance range
•
•
Output voltage
•
Output current
•
•
Switching frequency
•
•
•
Total current of the outputs
•
Cable length
•
Encoder
Connectable encoders
•
Interrupts/diagnostics/status information
Substitute values connectable
Alarms
•
Diagnoses
•
Diagnostics indication LED
•
•
•
Potential separation
between the load voltages
Potential separation channels
•
•
•
26
lower limit
upper limit
for signal "1", min.
for signal "1" rated value
for signal "0" residual current, max.
with resistive load, max.
with inductive load, max.
on lamp load, max.
Current per group, max.
unshielded, max.
2-wire sensor
–
permissible quiescent current (2-wire sen-
sor), max.
Diagnostic alarm
Short-circuit
Channel status display
for module diagnostics
For load voltage monitoring
between the channels, in groups of
between the channels and backplane bus
between the channels and the power supply
of the electronics
Digital input/digital output module DIQ 4+DQ 4x24VDC/0.5A 4xM12 (6ES7143-5AF00-0BA0)
6ES7143-5AF00-0BA0
48 Ω
4 kΩ
L+ (-0.8 V)
0.5 A
0.5 mA
100 Hz
0.5 Hz
1 Hz
2 A
30 m
Yes
1.5 mA
Yes; channel by channel, parameterizable
Yes; Parameterizable
Yes; Outputs to M; encoder supply to M; module
by module
Yes; green LED
Yes; green/red LED
Yes; green LED
Yes
4; DIQ channels are isolated from DQ channels
Yes
No; DIQ channels are non-isolated and DQ chan-
nels are isolated from supply voltage 1L+
Equipment Manual, 08/2021, A5E36683613-AB