Siemens SIMATIC ET 200AL System Manual page 901

Technical specifications
Technical specifications of the DIQ 16x24VDC/0,5A 8xM12 IO-Link digital input/digital output
module
The following table shows the technical specifications as of the issue date. You can find a
data sheet including daily updated technical specifications on the Internet
(https://support.industry.siemens.com/cs/de/en/pv/6ES7143-5AH00-0BL0/td?dl=en).
Article number
General information
Product type designation
HW functional status
Firmware version
Engineering with
•
Supply voltage
Load voltage 1L+
•
•
•
•
Load voltage 2L+
•
•
•
•
Input current
Current consumption (rated value)
from load voltage 2L+, max.
Encoder supply
Number of outputs
24 V encoder supply
•
•
Power loss
Power loss, typ.
IO-Link digital input/digital output module DIQ 16x24VDC/0,5A 8xM12 (6ES7143-5AH00-0BL0)
Equipment Manual, 08/2021, A5E47926885-AB
IODD file
Rated value (DC)
permissible range, lower limit (DC)
permissible range, upper limit (DC)
Reverse polarity protection
Rated value (DC)
permissible range, lower limit (DC)
permissible range, upper limit (DC)
Reverse polarity protection
Short-circuit protection
Output current, max.
6ES7143-5AH00-0BL0
DIQ 16X24VDC/0.5A, 8XM12
FS01
V1.0.x
Yes
24 V; Supply from 1Us+ of the IO-Link master
18 V
30 V
Yes; against destruction
24 V; Supply from 2UA+ of the IO-Link master
20.4 V
28.8 V
Yes; Against destruction; encoder power supply
outputs applied with reversed polarity, loads pick
up
20 mA; without load
4 A; Maximum value
8; Supply from 2UA+ of the IO-Link master
Yes; per module, electronic
0.7 A; Total current of all encoders (depending on
IO-Link master supply via 2UA+)
4 W
6
21