Siemens SIMATIC ET 200AL System Manual page 123

General information
Multiple bending, min.
Constant bending
Color of the cable sheath
Color of the wire insulation of the data wires
Weight per length
Mechanics/material
Type of cable outlet
Number of connectors
Connector housing material
Wire insulation material
Cable sheath material
Material property halogen free
Material property silicon free
* = Applies to cable lengths up to 10 meters.
Connecting cable for ET-Connection standard and PUR cable
You can use the connecting cable between two cables for ET-Connection.
Typical applications for using connecting cable for ET-Connection are:
• Combination of individual cable lengths by joining multiple pre-assembled cables for
ET-Connection.
• Selective installation of disconnection points of cables for ET-Connection (for simple
changing of cables and cable sections, e.g. with trailing-cable applications).
You can use a maximum of two connecting cables between the two modules.
The length of the cables for ET-Connection is limited to maximum 10 m when connecting
cables are used.
The connecting cable for ET-Connection is available in the following design:
• Connecting cable for bus cable ET-Connection M8, both ends assembled with 2x M8
socket, 4-pole, shielded, length 0.2 m
Distributed I/O system
System Manual, 08/2021, A5E31861578-AJ
Accessories/spare parts
40 mm
100 mm
Green
White, yellow, blue, orange
34 kg/km
180° cable outlet
90° cable outlet (with angled connectors)
1 or 2
Metal
PE
PUR
Yes
Yes
C.2 Cables
121