Siemens SIMATIC ET 200AL System Manual page 194

Procedure using S7-PCT
Connect the PG/PC to the PROFINET IO or PROFIBUS DP interface of the IO-Link master or to
your system.
Make sure that an online connection to the IO-Link I/O module exists.
1. Select an IO-Link I/O module in the project tree.
2. Select the "Parameters" tab in the work area.
3. Under "Parameters" > "Parameter Data" > "System command", click on the desired button:
• "Application Reset"
• "Restore Factory Setting"
Figure 8-2 Resetting a module
Result: The IO-Link I/O module is reset.
Reference
You can find more information on the procedure in the S7-PCT online help.
IO-Link I/O modules
System Manual, 08/2021, A5E48755395-AB
Maintenance
8.3 Resetting a module
51