Siemens SIMATIC ET 200AL System Manual page 241

Introduction
You connect the ET 200AL I/O modules via the BusAdapter BA-Send 1xFC via ET-Connection.
①
②
Figure 6-2
Required tools
Screwdriver with 3 to 3.5 mm blade
Required accessories
Use the bus cable for ET-Connection as connecting cable between the BusAdapter BA-Send
1xFC and the ET 200AL I/O modules.
We recommend using the Stripping Tool for ET-Connection (6ES7194-2KA00-0AA0) with
blade cassette green (6GK1901-1B...). This guarantees fast and safe stripping.
The bus cable is available in the following versions:
Bus cable for ET-Connection M8, prefabricated on one side with 1x M8 connector, 4-
pole, shielded
• Length 2 m: 6ES7194-2LH20-0AC0
• Length 5 m: 6ES7194-2LH50-0AC0
• Length 10 m: 6ES7194-2LN10-0AC0
• Length 15 m: 6ES7194-2LN15-0AC0
Bus cable for ET-Connection M8, PUR cable, prefabricated on one side with 1x M8
connector, 4-pole, shielded
• Length 2 m: 6ES7194-2MH20-0AC0
• Length 5 m: 6ES7194-2MH50-0AC0
• Length 10 m: 6ES7194-2MN10-0AC0
• Length 15 m: 6ES7194-2MN15-0AC0
Mixed configuration
Equipment Manual, 11/2020, A5E33344611-AD
BusAdapter BA-Send 1xFC
Connection element for ET-Connection bus cable
BusAdapter BA-Send 1xFC
Connecting
6.1 Connecting BaseUnit BU-Send
23