Siemens SIMATIC ET 200AL System Manual page 61

Configuring
Introduction
You configure and assign parameters for the ET 200AL distributed I/O system (interface
modules and I/O modules) using STEP 7 or the configuration software of another
manufacturer.
Requirements
Table 6- 1
Configuration software
STEP 7 Safety (TIA Portal) as of V17 for
modules:
•
STEP 7 (TIA Portal) as of V14 for mod-
ules:
•
•
STEP 7 (TIA Portal) V13 SP1 or higher
for modules:
•
•
STEP 7 (TIA Portal) V13 SP1 or higher
for modules:
•
•
STEP 7 (TIA Portal) V13 SP1 or higher
for modules:
•
•
•
•
•
•
Distributed I/O system
System Manual, 08/2021, A5E31861578-AJ
Configuration software and requirements
F-DI 4+F-DQ 2x24VDC/2A 4xM12
DIQ 16x24VDC/0.5A 8xM12
AQ 4XU/I, 4XM12
DI 8x24VDC 4xM12
DI 16x24VDC 8xM12
DIQ 4+DQ 4x24VDC/0.5A 4xM12
DQ 8x24VDC/2A 8xM12
IM 157-1 PN
IM 157-1 DP
DI 8x24VDC 8xM8
DIQ 4+DQ 4x24VDC/0.5A 8xM8
AI 4xU/I/RTD 4xM12
CM 4xIO-Link 4xM12
Requirements
• PROFINET-compliant F-CPU (with CP
expansion modules)
• PROFIsafe-compliant F-PLC controller,
2.6.X (RIOforFA safety profile) or
PROFIsafe 2.4
• PROFINET IO, PROFIBUS DP:
as of Support Package HSP 0194
• PROFINET IO, PROFIBUS DP:
as of Support Package HSP 0155
• PROFINET IO, PROFIBUS DP:
as of Support Package HSP 0156
• none, integrated in STEP 7
6
Installation in-
formation
STEP 7 online
help
59