Parameters
4.1
Parameters
The following table shows the parameters for the IM 157-1 DP interface module.
Table 4- 1
Parameters
Configuration control
Startup if preset configuration does
not match actual configuration
Diagnostics interrupt
Hardware interrupt
Pull/plug module interrupt
Note that the "Startup if preset configuration does not match actual configuration" parameter is
1
always activated when you use configuration control.
The defaults apply to the default startup. If no other parameters are specified by the DP master, the
2
interface moduleIM 157-1 DP starts up with these parameters.
4.2
Explanation of the parameters
Configuration control
You can use this parameter to enable the configuration control function in the ET 200AL
distributed I/O system.
Note
Configuration control
The configuration control function can only be used if you set the "Startup if preset
configuration does not match actual configuration" parameter to "YES".
20
Parameters
1
Value range
Default
Disable
•
Disable
•
Enable
Disable
•
Disable
•
Enable
Enable
•
Disable
•
Enable
Enable
•
Disable
•
Enable
Enable
•
Disable
•
Enable
Equipment Manual, 08/2021, A5E32100641-AE
Efficiency range
2
ET 200AL
ET 200AL
ET 200AL
ET 200AL
ET 200AL
IM 157-1 DP (6ES7157-1AA00-0AB0)
4