Siemens SIMATIC ET 200AL System Manual page 363

PROFIenergy
7.2 Behavior of the digital input module
Mode parameter
The following table shows the "Mode" parameter.
Table 7- 1
Element Code
Mode
As there is only one encoder supply U
1
"pause" if no channel is configured in PE_MODE_PROCEED.
26
Mode parameter
0 : PE_MODE_PROCEED
D
1 : PE_MODE_SHUTDOWN
D
3 : PE_MODE_LAST_VALUE
D
4 : PE_MODE_SUBST_VALUE
D
Explanation
Proceed at "pause"
• Value status "GOOD"
Switch off at "pause"
• Encoder supply U
• Pause substitute value: 0
• Value status "BAD"
Last value at "pause"
• Encoder supply U
• Pause substitute value: Last input value
• Value status "BAD"
Substitute value at "pause"
• Encoder supply U
• Pause substitute value: Configured pause substi-
tute value
• Value status "BAD"
for all channels, the supply can only be switched off at
S
DI 8x24VDC 8xM8 (6ES7141-5BF00-0BA0)
Equipment Manual, 08/2021, A5E32349579-AD
switched off
1
S
B
switched off
1
S
switched off
1
S