Siemens SIMATIC ET 200AL System Manual page 642

Mode parameter
The following table shows the "Mode" parameter.
Table 7- 1
Element Code
Mode
Encoder supply U
1
deactivated in these measurement types.
Analog input module AI 4xU/I/RTD 4xM12 (6ES7144-5KD00-0BA0)
Equipment Manual, 08/2021, A5E32350124-AG
Mode parameter
0 : PE_MODE_PROCEED
D
1 : PE_MODE_SHUTDOWN
D
3 : PE_MODE_LAST_VALUE
D
4 : PE_MODE_SUBST_VALUE
D
is only provided for measurement type current and voltage and can only be
S
7.2 Response of the analog input module
Explanation
Proceed at "pause"
• Value status "GOOD"
Switch off at "pause"
• Encoder supply U switched off
S
• Pause substitute value: 7FFF
• Value status "BAD"
Last value at "pause"
• Encoder supply U switched off
S
• Pause substitute value: Last input value
• Value status "BAD"
Substitute value at "pause"
• Encoder supply U switched off
S
• Pause substitute value: Configured pause sub-
stitute value
• Value status "BAD"
PROFIenergy
1
H
1
1
45