Select The Duration Of The Aspiration For The Cycle - Molecular Devices MultiWash+ User Manual

Select the Duration of the Aspiration for the Cycle

Define the duration time for the aspiration in the cycle from 0 seconds to 10.0 seconds. The
aspiration duration is the amount of time that the aspiration needle on the manifold stays
inside a well during aspiration.
Figure 6-4: The Aspiration Time prompt
Table 6-4: Actions of Control Panel Buttons
Button
On the left
On the right
5032022 C
Action
Press this button to return to the previous step. See
the Cycle on page 67.
Press this button to end the process and return to Define Cycle without saving any
changes. See Defining a Wash or Rinse Cycle on page
Press this button to add time to the duration in 1 second intervals to a maximum of
10 seconds.
Press this button to subtract time from the duration in 1 second intervals to a
minimum of 0 seconds.
Press this button to confirm the duration and then define the speed of the aspiration
for the cycle. See Select the Speed of the Aspiration for the Cycle on page
Chapter 6: Defining a Wash or Rinse Cycle
Confirm or Change the Name of
65.
70.
69