Select The Bottle For The Prime Or Rinse Process - Molecular Devices MultiWash+ User Manual

MicroWash+ Microplate Washer User Guide

Select the Bottle for the Prime or Rinse Process

Before you can run the periodic prime or rinse process, you must select the bottle to use.
The labels above the fittings where the bottles connect to the rear of the instrument match
the names of the bottles in the software.
Figure 4-17: Fittings for Fluid Bottle Connections
Figure 4-18: The Liquid prompt
Table 4-11: Actions of Control Panel Buttons
Button
On the left
On the right
44
Action
Press this button to end the process and return to Prime/Rinse. See
Rinsing the Fluidics System on page
The button has no function for this option.
Press this button to scroll forward through the list of wash and rinse bottles.
Press this button to scroll backward through the list of wash and rinse bottles.
Press this button to confirm the bottle selection and go to the next step. The software
displays a series of optional prompts to make sure that the instrument is ready for the
procedure. If no options have been enabled, then you can define the volume of liquid
to use for the periodic prime or rinse process. See
Prime or Rinse Process on page
31.
Defining the Liquid Volume for the
47.
Priming or
5032022 C