Select The Bottle For The Procedure - Molecular Devices MultiWash+ User Manual

Select the Bottle for the Procedure

The procedure uses the wash or rinse bottle defined in this step.
The labels above the fittings where the bottles connect to the rear of the instrument match
the names of the bottles in the software.
Figure 5-4: Fittings for Fluid Bottle Connections
Figure 5-5: The Liquid prompt
Table 5-4: Actions of Control Panel Buttons
Button
On the left
On the right
5032022 C
Action
Press this button to return to the previous step. See
the Procedure on page 53.
Press this button to end the process and return to Define Procedure without saving
any changes. See Defining a Procedure on page
Press this button to scroll forward through the list of wash and rinse bottles.
Press this button to scroll backward through the list of wash and rinse bottles.
Press this button to confirm the bottle selection and then select a previously defined
cycle to use with the procedure. See
Chapter 5: Defining a Procedure
Confirm or Change the Name of
51.
Select the Cycles for the Procedure on page 56.
55