Enable The Number Of Strips Prompt For The Procedure - Molecular Devices MultiWash+ User Manual

MicroWash+ Microplate Washer User Guide

Enable the Number of Strips Prompt for the Procedure

Enable or disable the prompt to define the number of strips to process during the
procedure. This can be useful to process a partial microplate or only a few strips in the
procedure.
Figure 5-12: The Ask Strip Number prompt
Table 5-11: Actions of Control Panel Buttons
Button
On the left
On the right
62
Action
Press this button to return to the previous step. See
the Procedure on page 61.
Press this button to end the process and return to Define Procedure without saving
any changes. See Defining a Procedure on page
Press this button to display either Yes to enable the prompt or No to disable the
prompt.
Press this button to display either Yes to enable the prompt or No to disable the
prompt.
Press this button to accept the selection. If you selected Plate as the processing
mode, then the parameters for the procedure definition are saved. If you selected
Strip as the processing mode, then you can select to delay the final aspiration. See
Delay the Final Aspiration for Strips in the Procedure on page
Select the Microplate Type for
51.
63.
5032022 C