Molecular Devices MultiWash+ User Manual page 33

Select the Bottle for the Prime or Rinse Process
Before you can run the manual prime or rinse process, you must select the bottle to use.
The labels above the fittings where the bottles connect to the rear of the instrument match
the names of the bottles in the software.
Figure 4-3: Fittings for Fluid Bottle Connections
Figure 4-4: The Liquid prompt
Table 4-2: Actions of Control Panel Buttons
Button
On the left
On the right
5032022 C
Action
Press this button to end the process and return to Prime/Rinse. See
Rinsing the Fluidics System on page
The button has no function for this option.
Press this button to scroll forward through the list of wash and rinse bottles.
Press this button to scroll backward through the list of wash and rinse bottles.
Press this button to confirm the bottle selection and go to the next step. The software
displays a series of optional prompts to make sure that the instrument is ready for the
procedure. If no options have been enabled, then the manual prime or rinse process
can be started. See Controlling the Manual Prime or Rinse Process on page
Chapter 4: Priming or Rinsing the Fluidics System
31.
Priming or
36.
33