Delay The Final Aspiration For Strips In The Procedure - Molecular Devices MultiWash+ User Manual

Delay the Final Aspiration for Strips in the Procedure

For Strip processing mode only, you can select to delay the final aspiration until after the last
cycle for the last strip is complete and the soak time has expired.
Figure 5-13: The Delay Final Aspiration prompt
Table 5-12: Actions of Control Panel Buttons
Button
On the left
On the right
5032022 C
Action
Press this button to return to the previous step. See
Prompt for the Procedure on page
Press this button to end the process and return to Define Procedure without saving
any changes. See Defining a Procedure on page
Press this button to display either Yes or No. Select Yes to delay the final aspiration
until after the last cycle for the last strip is complete and the soak time has expired.
Press this button to display either Yes or No. Select Yes to delay the final aspiration
until after the last cycle for the last strip is complete and the soak time has expired.
Press this button to accept the selection. The parameters for the procedure
definition are saved.
Chapter 5: Defining a Procedure
Enable the Number of Strips
62.
51.
63