Gate Resistance Calibration - R G - Keysight PD1500A System Installation Manual

Double-pulse test rack and safety enclosure

Hide thumbs Also See for PD1500A:

Table of Contents

PD1500A Double-Pulse Test System Calibration

Gate Resistance Calibration – R

This step is required when installing custom gate resistors on the High-Side and

Low-Side Gate Drive modules.

Hardware Setup:

Banana - BNC Adapter

Low-Side Gate

Drive Module

Figure 9

Setup for the Gate Resistance Calibration 4-Wire Measurements

Procedure:

After setting up the hardware as described above, click Start to perform the

calibration and continue to the High Voltage Probe Calibration.

See Figure 9 below.

– Install the I/NO Jumper on the Low-Side Gate Drive Module.

– Install the V/NC Jumper on the Low-Side Gate Drive Module.

– Refer to Figure 9 below. Install both calibration cables to connect the

B2902A SMU to the Low-Side Gate Drive module.

– The Safety Enclosure hood may be left open.

1251-2277

IMPORTANT: After the R

removed from the Low-Side Gate Drive Module.

There is no calibration for the 0 Gate Drive modules or the

High-Side Gate Drive modules.

System Calibration Procedure (Autocal)

8121-2816

BNC - SMA

Cable

I/NO (Normally Open) Jumper.

V/NC (Normally Closed)

Jumper

Calibration, the I/NO jumper must be

Keysight Double-Pulse Test System Installation Guide

U1168B Standard Probe Kit

Table of Contents