Install Oscilloscope In Safety Enclosure Hood; Prepare The Rack And Safety Enclosure - Keysight PD1500A System Installation Manual

Double-Pulse Test System
Installation Guide
3 Install Oscilloscope in Safety
Enclosure Hood
The Keysight 33512B Waveform Generator, B2902A SMU, and Heinzinger EVO
High Voltage Power Supply are already installed inside the Double-Pulse Test
Rack and Safety Enclosure.
The Keysight DSOS104A Oscilloscope and the DPT Test Fixture sit on top of the
Work Surface inside the Safety Hood and must be installed by the Keysight AE.
This chapter provides detailed instructions for installing the oscilloscope in the
Rack and Safety Enclosure.
In this Chapter:

Prepare the Rack and Safety Enclosure

Prepare the Rack and Safety Enclosure
Install DSOS104A Oscilloscope Inside the Safety Hood
34
Connect LAN, Power, and Trigger Cables to the
Oscilloscope
Connect Oscilloscope Probes to Oscilloscope
Do not remove the front or rside panels from the enclosure. There
are no user-serviceable parts inside.
The Heinzinger EVO High Voltage Power Supply must have
firmware revision P001.005 or greater. Refer to the supply's user
documentation to determine which version is currently installed.
Contact Heinzinger for specific firmware updating information.
page 33
page 35
page
page 37
33