Table of Contents
Advertisement
Uncrate the Rack and Safety Enclosure
Rack and Safety Enclosure System Hardware Components
Verify that your Rack and Safety Enclosure system includes the following test
instruments before beginning to install the DPT system:
The following instruments must be installed on the Rack
and Safety Enclosure by a Keysight Application Engineer. These instruments are
shipped separate from the Rack and Safety Enclosure:
Additionally, you may have received several boxes that include the PD1500A Test
Fixture and test modules, various cables, oscilloscope probes, and other
miscellaneous parts.
1 The "T" wrench is used only during initial installation of the PD1500A Rack and Safety Enclosure. Under normal
use, the Safety Hood remains locked when the system is powered and functional. Refer to the PD1500A Test
Rack and Safety Enclosure Operation and General Maintenance Guide for information.
30
– A Rack and Safety Enclosure. Included with the rack are:
-- A mains power cord (Type A, IEC-60320 C19 to
Type B Free End) is supplied with the PD1500A
Rack and Safety Enclosure.
-- A triangle "T" wrench for manually releasing the
Safety Hood if necessary.
-- Instrument LAN cables, a LAN Switch, a Power
Distribution Unit (PDU), and all of the safety
electronics are pre-installed in the rack.
-- a Keysight DSOS104A 4-Channel Oscilloscope (sits on top of the rack
inside the clear Safety Enclosure). See "Install Oscilloscope in Safety
Enclosure Hood" on page 33.
-- A DPT Test Fixture with Test Modules. "Install Test Fixture in the Safety
Enclosure Hood" on page 39.
Rack and Safety Enclosure System Hardware Components
1
Keysight Double-Pulse Test System Installation Guide
Advertisement
Table of Contents
