Connect Lan, Power, And Trigger Cables To The Oscilloscope - Keysight PD1500A System Installation Manual

Connect LAN, Power, and Trigger Cables to the Oscilloscope

Connect LAN, Power, and Trigger Cables to the Oscilloscope
1 Connect the two LAN cables to the RJ-45 connectors. Connect the LAN cable
2 Connect the BNC cable to the oscilloscope AUX Trigger IN (50) port on the
3 Connect the power cord to the AC power input jack on the right side panel.
Figure 3
Keysight Double-Pulse Test System Installation Guide
marked LAN System to the top LAN connector; connect the LAN cable marked
LAN Switch to the bottom LAN connector.
right side panel of the oscilloscope.
Right Side of DSOS104 Oscilloscope
For the two oscilloscope LAN cables, the one marked Lan Scope
must go to the top LAN port on Scope. The cable marked LAN
Switch or LAN Ext must go to the bottom LAN port on scope. If
these are reversed, the Control Software on the Host Computer
cannot communicate with the oscilloscope or other test
equipment.
You may need the oscilloscope keyboard and mouse for initial
setup. Otherwise, do not plug a keyboard or mouse into the
oscilloscope.
Install Oscilloscope in Safety Enclosure Hood
Trigger Cable
from N1294A
Option 31 GPIO -
BNC Trigger
Adapter connects
here
Cable marked
"LAN Scope"
Cable marked
"LAN Ext"
AC Power Input
35