Moving The Rack And Safety Enclosure - Keysight PD1500A System Installation Manual

Double-pulse test rack and safety enclosure

Hide thumbs Also See for PD1500A:

Table of Contents

Moving the Rack and Safety Enclosure

The Rack and Safety Enclosure has four wheels on the bottom of the rack. Be

careful, the rack's center of gravity is high. The rack might tilt over when moving.

All four wheels have locking mechanisms. Ensure the wheels are locked when

using the DPT Rack and Safety Enclosure.

After all of the test equipment is properly installed and secured in the Rack and

Safety Enclosure, it may be necessary to move the system to a new location.

Shut down the system correctly as described in the manual. Make sure the line

power connection was removed correctly from the system. Make sure there is no

energy left in the circuits by discharging all circuits to earth. Disconnect all

adapters from the system. Disconnect all peripherals that are connected outside

the system. Make sure there are no loose components inside the system rack.

Keysight Double-Pulse Test System Installation Guide

IMPORTANT: The DPT Rack and Safety Enclosure has four wheels or

casters on the bottom. These casters are lockable to prevent the

rack from moving. Make certain the wheel locks are disengaged

before moving the rack.

Be very careful when moving the Rack and Safety Enclosure

around. The rack's center of gravity is high and the rack might tilt

over when moving. Also, the DSOS104 Oscilloscope and the DPT

Test Fixture are not secured to the top of the rack. They may slide

around if the rack tips.

Uncrate the Rack and Safety Enclosure

Table of Contents