Turn-On And Software Installation; After Installing Oscilloscope And Test Fixture In The Dpt Test Rack - Keysight PD1500A System Installation Manual

Turn-on and Software Installation

After Installing Oscilloscope and Test Fixture in the DPT Test Rack

After installing the DSOS104A Oscilloscope and PD1000A Test Fixture, do the
following:
1 Install Keysight IO Libraries on the host PC.
2 Install the PD1000A Control Software on the host computer. Complete details
3 Run a complete DPT system calibration. Complete instructions are provided in
PD1000A Control Software for Double-Pulse Test System. This is the software that
controls the test equipment to make the characterization measurements. Refer
to the PD1000A Control Software help file for detailed information on using the
PD1000A Control Software.
48
for installing the software are provided in the PD1000A Startup Guide or the
PD1500A Software Guide.
the PD1500A Software Guide.
The PD1000-60002 Protection Probe requires Infiniium
Oscilloscope Software for Windows 10, version 06.40 (or later) in
the DSOS104 Oscilloscope. Verify the current installed version in
the DSOS104 Help > About screen. You can download and install
the latest version of firmware from:
DSOS104A. Select Drivers, Firmware & Software, then Instrument
Firmware/Software.
After Installing Oscilloscope and Test Fixture in the DPT Test Rack
www.keysight.com\find\
Keysight Double-Pulse Test System Installation Guide