Step 1 - Connect To A Compatible Keysight Oscilloscope; Compatibility With Oscilloscopes - Keysight N7040A User Manual

3 Overview

Step 1 - Connect to a Compatible Keysight Oscilloscope

Compatibility with Oscilloscopes

NOTE
Infiniium Oscilloscopes
S-Series
9000 Series
9000 H-Series
Infiniium Software Version
Compatible with all Infiniium
software versions
Recommended version: 6.10 or
higher
To connect to a compatible Keysight oscilloscope
Before you start setting up the probe, ensure that all safety warnings and precautions listed in the
topic
1
24
You can use these probes with any Keysight Infiniium or InfiniiVision oscilloscope that has the
1MΩ BNC input.
InfiniiVision Oscilloscopes
6000L Series
6000 X-Series
4000 X Series
3000 X Series
3000T X Series
2000 X Series
1000 X Series
1000 Series
InfiniiVision Software Version
Compatible with all InfiniiVision
software versions
"Pre-Use Safety Checks and Warnings"
Connect the probe's BNC output connector to the oscilloscope's BNC input connector using the
BNC cable provided with the probe.
Grounding is critical to the safe operation of the probe. This connection
WARNING
using the BNC cable grounds the probe and coil to a properly grounded
oscilloscope.
This connection must always be made BEFORE the coil is wrapped
around the conductor under test and must not be removed until the coil
has been removed from around the conductor under test.
Extreme caution needs to be taken not to damage coil insulation when
placing or removing coil around sharp conductors.
on page 20 and 19 are followed.
N7040A/1A/2A Rogowski AC Current Probes User Guide