User Manual
GFK-2958J
11.1
Disassembling the RSTi-EP Station
WARNING
Explosion Risk - Prior to starting work, ensure that there is not a potentially explosive
atmosphere.
CAUTION
Dangerous contact voltage - Carry out all disassembly work on the RSTi-EP station only
when the power supply is disconnected. Ensure that the place of installation (switch
cabinet and such) has been disconnected from the power supply.
•
1. Remove all cables and lines.
2. Remove the end bracket marker (if present).
3. Unfasten the mounting screw on the right-hand end bracket.
4. Slide the end bracket with the end plate to the right and remove both from the
5. Press all the release levers of a module group towards the mounting plate so that
6. Slide the module group to the right and remove it from the DIN rail.
7. Repeat the above procedure for all remaining modules/ module groups.
8. To disassemble the field-bus network adapter, open both release levers and
9. Unfasten the mounting screw on the left-hand end bracket and remove it.
10. Observe the instructions for proper disposal.
11.2
Disposing of the RSTi-EP Station
Attention
When all RSTi-EP products reach the end of their life cycle, you can return them to Emerson,
and we will arrange for their proper disposal. This also applies to countries outside the
European Union.
Disassembly and Disposal
Disassembly and Disposal
To disassemble the RSTi-EP station
DIN rail.
You can now disassemble the modules and the field-bus network adapter either
individually or in groups of three to four modules.
they click into place.
remove it from the DIN rail.
Products in the RSTi-EP series are subject to WEEE (EU Directive
2002/96 EC), which regulates the collection and recycling of electrical
and electronic equipment. Ensure that disassembled products are
properly disposed of.
Chapter 11
Oct 2019
401