Configuring Epxpns001/Epxpns101 Parameters - Emerson PACSystems RSTi-EP User Manual

User Manual
GFK-2958J
The device name, IP address of the EPXPNS001/EPXPNS101 can be changed by right-
clicking on the scanner and selecting properties.
Figure 227
Note
: When firmware is updated, the IP address is not retained when configured using the master module.
But when configured in web server and the same IP is used in the master, it is retained during PROFINET
Network Adaptor firmware update.

Configuring EPXPNS001/EPXPNS101 Parameters

After adding a EPXPNS001/EPXPNS101 to the LAN, its parameters can be configured by
either double-clicking on the scanner in the Navigator, or right-clicking and selecting
Configure from the menu.
PROFINET Scanner Parameters (Redundancy Tab) for
(EPXPNS101 only)
This Tab is available only for EPXPNS101 and not for the EPXPNS001 module. If the
EPXPNS101 must be used for PROFINET System Redundancy with HSB system (Type S2),
then the "Redundancy Mode" parameter needs to be set as "HSB CPU Redundancy".
Figure 228
Commissioning
Chapter 8
Oct 2019
352