Led Indicators Ep-7641 - Emerson PACSystems RSTi-EP User Manual

User Manual
GFK-2958J
The maximum feed-in current in the output current path via the 4-pole connector is 10 A.
Details required to calculate current demand and power supply are presented in Section 3.5,
Current Demand and Power Supply.
Power-feed modules are passive modules without fieldbus communication, therefore they
are not considered during configuration.
Note:
CAUTION
In the case of a maximum power supply of >8 A and a maximum temperature of > +55°C
(131 °F), all four contacts must be connected with 1.5 mm² wiring.

LED Indicators EP-7641

For error messages refer to Chapter 12:, LED Indicators and Troubleshooting.
Detailed Description of I/O Modules
A maximum of three passive modules (power-feed module, potential distribution module, empty slot
module) may be installed in succession, however the next module to be installed must be an active
module.
Module Status
4.1
4.2
4.3
4.4
Green: Voltage applied and is > 18Vdc
Green: Supply voltage for input current
path > 18Vdc
Red: Supply voltage for input current path
< 18Vdc
--
Red: Internal fuse defective, replace
module
Chapter 5
Oct 2019
310